If your dishwasher door is leaking, not closing correctly, or has cracks or chips, it may need to be repaired. Depending on the severity of the damage, a dishwasher door repair may be as simple as replacing a seal or gasket, or it may require replacing the entire door. Here are some information from dishwasher repairs experts in Joondalup WA.
Dishwasher Door Repair
Most dishwasher doors are attached to the dishwasher with two or three hinges. Over time, these hinges can become loose or even break, causing the door to sag or become difficult to open and close. If your dishwasher door has any of these problems, it’s time to repair or replace the hinges.
How to Repair a Dishwasher Door
If the door doesn’t latch, water from the dishwasher will spill on the kitchen floor and create an uncomfortable mess. Also, the dishwasher may not turn on.
Before fixing the door, make sure that the dishwasher is unplugged and the water supply is turned off.
1. Open the dishwasher door and remove any screws or bolts holding the hinges in place. If the hinges are severely damaged, you may need a chisel to remove them.
2. Once the old hinges are out, you can install the new ones. Start by attaching the top hinge, then the bottom hinge. If you’re using three hinges, attach the middle hinge last. Once the new hinges are in place, screw or bolt them into place.
3. Finally, turn the water back on and plug in the dishwasher. Test the door to make sure it opens and closes smoothly. If it doesn’t, you may need to adjust the hinges.
Dishwasher Door Spring Repair
If your dishwasher door cannot open or close properly, it may be due to a broken door spring. While this is not a common problem, you can quickly fix it with a few tools and a little know-how.
1. Before beginning any repair, it is important to disconnect the power to the dishwasher. It can be done by either unplugging the unit or shutting off the breaker that supplies power to it. Once the power is off, open the dishwasher door and locate the door springs. There are usually two springs, one on each side of the door.
2. Using a socket wrench or another type of wrench, remove the nuts that hold the springs in place. Once you remove the nuts, the springs can be pulled out and replaced with new ones. To install the new springs, reverse the process. Be sure to tighten the nuts securely so that the springs don’t get loose.
3. Once you replace the springs, test the dishwasher door to make sure it opens and closes properly. If the door still does not operate correctly, the problem may lie elsewhere and need to be addressed by a qualified technician.
Conclusion
Your dishwasher will not work if the door is damaged. Although it seems fitting to repair the door yourself, it may cost you much more in the long term, especially if you do not know about repairing dishwasher doors. Ensure you hire a professional to do the work correctly and efficiently. You get to save more time figuring out how the door repair works and more money in the long term.
Back to top: Dishwasher Door Repair
